Cadillac XLR Net - The ultimate online hub for Cadillac XLR owners and enthusiasts!
Supporting Membership - Supporting Vendors / Dealers - Advertise With Us

Thanks Thanks:  0
Dislikes Dislikes:  0
Results 1 to 3 of 3
  1. #1
    Junior Member
    Join Date
    Oct 2018
    Location
    anniston al
    Posts
    2
    Post Thanks / Like

    Cadillac XLR

    2009 red xlr/v

    Default 2009 xlr/v tilt and telescopic steering not working

    Long story but I will keep it short. All started when remote #2 would not let drivers seat escape when door open. Remote #1 work fine. Friend brought scan tool over and read code, had a few but nothing big, cleared them. Run scan, it did not find as many modules as before. Seat still will not escape. He ran a test on system, wheel tilts, but did not see it go in and out. Went to inputs, tool shows a input to tilt and telescope, but now not showing a output to make them work. It is like the computer is not telling it to tilt and telescope, but computer is getting a input. We disconnected the battery and grounded the pos side for about 5 min, tryed it again, still the same problem. With fob #1, everything works and changes settings but wheel will not tilt or move in and out. He is going to do some reading and come back tonight. Anybody got any "try this" ideas. The tilt and telescope worked before he cleared codes and ran test. It is kinda like it stayed in test mode.

  2. #2
    Junior Member
    Join Date
    Oct 2018
    Location
    anniston al
    Posts
    2
    Post Thanks / Like

    Cadillac XLR

    2009 red xlr/v

    Default

    I have the seat escape working now, all systems are normal, but the computer seems to not send the command (output) the the tilt and telescope.
    For you program guys, is there something in the GM program that would turn the outputs off. The scan tool we used does not have the ability to
    change a GM program.
    Thanks

  3. #3
    Pit Crew
    Join Date
    Sep 2008
    Location
    Uncanny Valley, New England
    Posts
    1,018
    Post Thanks / Like

    Cadillac XLR

    2013 Graphite Metallic XTS Platinum

    Default

    Steering wheel position for exit and entry is retained in the driver door module under the seat. Check the connector under the steering column first.
    Last edited by ccclarke; 11-02-2018 at 02:57 PM.

  4. Likes long Tall Sally liked this post

Tags for this Thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Cadillac, XLR and XLR-V are registered trademark of the General Motors Corporation & Cadillac Motor Division.  Neither Cadillac Motor Division nor any subsidiaries of GM© shall bear any responsibility for XLR-Net.com content, comments, or advertising. XLR-Net.com is independent from GM© and is not affiliated with, sponsored or supported by GM©.  Copyright/trademark/sales mark infringements are not intended, or implied.  All Rights Reserved