tom88ci
Active Member
I had seen a few posts about this issue here but wanted to share my experience. At 14792 miles I got the "Service Stabilitrak" message on the DIC. There is a TSB on the issue - TSB #07-05-25-002. I connected the TECH2 and I was getting the C0561 DTC. The fix was to reprogram the EBCM through the TIS2000 using the TECH2. Following the instructions it worked perfectly as the program was passed to the TECH2 and then downloaded to the EBCM. The error message is gone and no codes are active. I have a TECH2 clone and so far it has done everything it supposed to do.
I am sure many people take their car to a dealer for this fix and pay too much. And I don't recommend programming your own car if you have not used this type of equipment before.
I hope this helps.
I am sure many people take their car to a dealer for this fix and pay too much. And I don't recommend programming your own car if you have not used this type of equipment before.
I hope this helps.
Last edited: