Welcome to the Cadillac XLR Forums!

Search results

  1. justdennis

    Transmission linkage failed, parking brake on and top is down

    You're welcome Good luck on the repairs, hopefully it's just the rear cable bushing. That's the easier one to replace, you can see it just in front of the trans when you look up between the exhaust pipes. You can easily reach up an shift the trans into park from there also.
  2. justdennis

    Transmission linkage failed, parking brake on and top is down

    There is a leaver just above the floor light by the emergency brake, hard to see unless you remove the cover plate but if you reach your finger up just past the light you will find it. I don't know for sure but I think that will release the brake. Safety first, good luck.
  3. justdennis

    Help! Sirus XM Radio Function

    No problems at all, it has worked from day one.
  4. justdennis

    Help! Sirus XM Radio Function

    I have a 2007 V with XM and it works great and no antenna on the trunk.
  5. justdennis

    Help! Scan Tools

    I have the Tech2 and I'm still learning it's capabilities but it seems to do everything I have needed and has already saved me money. I tried a scanner made by Xtool, do not buy that one. Not only did it not work for the XLR, it caused problems that I was able to fix with the Tech2.
  6. justdennis

    New Owner

    Welcome to the club and congratulations on your new car purchase.
  7. justdennis

    New to the Forum and Looking for Help

    Have you got it out of park yet?
  8. justdennis

    Looking for front valance end pieces

    I believe they are called left and right valance (air dame) they mount under the front bumper. I have the center piece but I need both ends. Any help? Thanks, Dennis
  9. justdennis

    Help! Programming 2009 XLR Key-fob

    You have to try everything, what do you have to lose. There is always the chance it's defective, it sounds like you're doing everything right. Good luck
  10. justdennis

    Help! Programming 2009 XLR Key-fob

    Dumb idea #1, put a battery in the new fob. Dumb idea #2, try it with the buttons facing to the left. That's all I got
  11. justdennis

    New to XLR Forum

    I like it!
  12. justdennis

    Help! need to replace the dash pad on my 06.

    I think you need to remove the windshield post covers first, the drivers side has the microphone in it so be careful removing the wires. My memory is a little fuzzy on this but I believe you need to remove the center stack face plate because there is a screw holding down the dash cover by the...
  13. justdennis

    Many error codes

    I have found that a lot of the problems with my car were due to loose wire connections, I would start there before you spend any more money. Inspect and clean every wire connection you can find, including grounds. Even if it doesn't help you will learn a little more about your car. Good luck...
  14. justdennis

    Service Radar Cruise

    That makes sense.
  15. justdennis

    Service Radar Cruise

    There is a factory reset for that on my Tech2 but I have a V so it doesn't apply for my car. I believe it's in the BODY section. If you have a Tech2 you may be in luck.
  16. justdennis

    car wont go into gear, shifter just floats back and forth from park to drive..and doesnt engage!!

    The only thing I can suggest is get the rear end off the ground, get under the car and manually move the shifter arm at the trans and make sure it's not a shifter cable adjustment problem.
  17. justdennis

    Need a replacement accelerator - 2009 XLR

    This may not help you but in the year and half I have owner my XLR V I have found most of the problems I have had were related to loose connections. It's worth checking out. Good luck
  18. justdennis

    New to the Forum and Looking for Help

    Dan, Are you having any luck with your shifting problem?
  19. justdennis

    New to the Forum and Looking for Help

    Yes, there are two and they are on the right side of the shifter. If you look in that area while you try to press the rod on the top of the shifter you will see how it tries to move a small plastic piece but is held up by another piece, there is a small rod there if you slide it forward then you...
  20. justdennis

    New to the Forum and Looking for Help

    Dan, Is the reason you can't shift out of park because you can't pull the trigger on the shifter? When you push on the brake do you hear a clicking at the base of the shifter, if not that could be your problem. There is a safety switch that when energized releases the trigger allowing the...
Back
Top Bottom