Search results

Yes, there are two and they are on the right side of the shifter. If you look in that area while you try to press the rod on the top of the shifter you will see how it tries to move a small plastic piece but is held up by another piece, there is a small rod there if you slide it forward then you...

Dan, Is the reason you can't shift out of park because you can't pull the trigger on the shifter? When you push on the brake do you hear a clicking at the base of the shifter, if not that could be your problem. There is a safety switch that when energized releases the trigger allowing the...

I agree with rexster, I purchased a Tech2 a few months back and have used it to do a relearn on the column calibration and it worked fine without TIS. I did try to load it but failed, it would seem even our three old moth balled computers still are too new to get it done.

Congratulations on your new purchase, welcome to the club.

Welcome Ray, I bought my ticket to ride about a year and a half ago and it's still a thrill to drive. Enjoy!

Welcome CY, enjoy it.

You're welcome, enjoy the ride.

Make sure all the air dampers are wide open, I know mine makes more noise when they are closed. Actually the motor/fan is not too hard to get at, above the passenger floor there is a cover plate under the dash that comes off fairly easily and then it's just 3 screw and a wire connector. It has...

Welcome to the club

It is 160 and there is a "MPH" light in the upper center of the speedometer. Your car may have been built for export and could be in kilometers, just a guess. If that's the case it has very low miles, either way it sounds like a very nice car.

I have a 2007 V; my tach has the V emblem, and the speedometer has Bulgari spelled around the perimeter. I'm not sure what you mean about the odometer.

Welcome to the club.

Welcome to the club

In order for anyone to try and help we need more information. What did the diagnostic test tell you, what code or codes were you getting, which sensor was it and was it always the same one. Who replaced them you or a paid mechanic?

I do have that so hopefully that's all I'll ever need. Thanks

I did not realize that it could do that without the TIS2000 software, good to know.

Thanks for your words of caution, I hear ya. I have not been able to load the TIS2000 software yet, but I'm working on it. Even without that it has already fixed the problem I created when I tried to use an Xtool D7. By the way... DO NOT BUY AN XTOOL SCANNER.

I just purchased a new Tech 2 and I was wondering if any of you that have some experience using one of these could give me a few pointers. I'm sure I will figure it out but if you know of any do's or don'ts, I would appreciate the help. Thanks, Dennis

Glad to hear that worked for you, we need all the AC we can get here in Florida.

The problem might be that you are low on refrigerant, Scotty Kilmer did a youtube about that same problem. Good luck