Search results

And checking that bolt is difficult because the steering rack is in front of it, so that has to come out, which means removing the front suspension and spring, for which the special tool to release the spring is required.

Can you clarify this? It is only necessary to remove the driver's side rear wheel and inner fender to get to the gas release solenoid mechanism (as well as from inside the trunk). The work outside the car is easy, routine stuff. The work inside the trunk is tricky in that it is awkward and...

At post #9, I put what you have to do to lubricate the whole mechanism.

With difficulty. Look for easy solutions first and the easiest is to check where you keep the fob. If it is close to your XLR, then it will keep the car 'awake'. A common mistake is to store to fob inside the house next to the door into the garage, so while there is a wall between the fob and...

Probably not the same cause, but I have had the ACC disengage when it has been jammed by another signal, at least, that is what I have always assumed it to be. Works fine and then just dops out and will re-enage immediatly (ie I press the button), then no problems again. It is a rare occurance...

For anyone doing a search on this topic, solenoid might be helpful.

Let me support what CC said, you NEED the correct special tool for that transverse spring, do not attempt the job without the correct tool. There is a lot of energy in the spring and you have to pull it off the suspension. There must be Corvette specialists in Germany surely?

Glad it has worked for a month. Should it happen again (and it might), you need to suspect two possible problems: 1/ The sensor (switch) on the brake pedal is failing, easy to replace 2/ A corrosion problem in the BCM at the harness end for the brake pedal position sensor. Several have...

The latch either releases or it doesn't. On lock, it pulls down. Once released the decklid is powered by hydraulics, the latch is physically too far away to have any influence in decklid operation.

Glad it is fixed.

I agree w CC, that ring comes off pretty easy. It has a very slight 'dimple' type retainer on the left and right sides moulded into the plastic (not front and back), if you gently pry the ring open wider to the left and press down and then repeat on the right, it pops right off (down). Use a...

If (and I do mean if), if everything is working correctly, using the key engages the pump and the deck lid lifts automatically. However, if there is a fault, it has to be raised by hand. The geometry of the key location and effort required to raise the deck lid by hand is such that it is a two...

Cleaning the MAF is a good move too; it takes more than one tank of premium to work through. After three tanks, then time to consider other options. All four O2 sensors have been replaced right? You have had the induction checked for leaks too right? If so, replacing the MAF might be a step...

While too late for now, look for leather treatments which help to waterproof the leather for the future.

See in-line above.

No, you have a fault in the dash start switch if that can happen. I have an idea there is a thread here on that fault, and/or is there a recall on it? This could be your problem. BTW, the brake vacuum reservoir is pretty standard across all domestic vehicles. A standard test of brake vacuum is...

That question has been asked here before. It is non-trivial.

Shell is a good brand, but while Cadillac state that the XLR will run on regular grade gas, your X should be run on premium grade, the engine management will take advantage of it. I might have read that the Shell top grade is a gas to liquid process (ie the opposite of cracking) and that is it...

You should get a warning in the DIS if the shifter is in the wrong gear or the brake pedal isn't pressed. As you don't mention that, I would look elsewhere. It is possible for a new battery to be defective, it happens. Analysing symptoms at a distance is unreliable, but the firmer brake pedal...

What brand (not grade, though premium is recommended) of gas are you using? The CEL should not be on. It might be worth trying a premium brand of gas (if you are not currently) for a while to see if that helps.