Recent content by Michael B

Purchased a new one . Installed didn't work properly,but different from the old one. Finally broke down and cleaned connection and now working properly. Thanks everyone Mike

Clean connection so far so good. You would think after 3 years I would know to do that . I'm electrician as well. Thanks much.

I got from ebay . In gm original parts. Do not have number, I disposed of bag.lol. temp reading now is working but plunges to - degree in the morning when was setting at 75 degree. I haven't disconnect ed battery yet and drained residual current. Should I ? Will that reset?

How to reset. Installed new sensor.

Installed new sensor. Displays correct temp. When sitting overnight but then quickly goes to -25 or less displays freeze warning. I've seen several procedure for reset but nothing successful so far. If it disconnect battery haven't done that yet. Anybody?

What was the cost and does it also carry the oil cooler?

Steering wheel position sensor. Puts you in safe mode. No power. They say the connection can be loose because of operation power tilt. No true in my opinion. It doesn't move any. I did my own. Best to take drivers seat out. It's not that hard to do. Get GM parts. Ebay has some. Dealership want...

I'd tape a piece of tint your thinking of using. The actual tint. Sometimes they look for a reason to pull an XLR over. Most people have never seen one. Lol

904-607-9264 mike

I've used original gm tech and the supposed knock of. Both work fine . You can get the aftermarket one for under 300. On eBay. I purchased both of mine from there. The port is beneath steering column. You will also need the gm card which is about $32.00 Ebay also. Still learning but have made...

My soon to be ex has taken my tech . I just repaired my circuit board and reconditioned the motor. All back together. Need to borrow a tech from someone close please . I'm in Slidell Louisiana

I've had both my seats out. I don't believe there's any cooling module. I believe the fan just picks up cool air from the car and blow's it up threw the perforated seat insert. Anybody else see anything different?

I'll certainly check that out. Thanks

I used moly grease. Its slicker than owl sh_t. Also the fuel release in truck , if you pull it the pin will pop back out. Wd-40 always a good choice as well