Recent content by MR Roadster

My tech2 is a reliable backup. Xtools D7 is cheaper than the Tech2 and is useful for all makes and models. I needed a modern Scanner for my Lexus and Silverado. My tech2 only went up to 2009.

I don't blame you for that. I really like the d7 because it is small and easier to use and works on other makes. Plus it can save reports and record real time data. I use it for bench testing my suspension bypass modules.

Not yet, but only because I haven't needed to use the procedure.

Well I found out why my tilt wheel would not fully go to the up position. There was a error code b2355-17 driver vertical position sensor this caused the seat calibration on the tech2 to not work. It stated "clear codes before calibration" I tried clearing the code but that didn't work. So next...

I read you were having problems with the tilt wheel after hooking up the xtools d7 scanner. Did you ever resolve the issue? My tilt will only go up half way. It will tilt down and in and out. But not up all the way.

Thank you for the follow up on your project. Happy motoring.

That's correct once the bypass is installed the old suspension module can be removed. I've also created a new plug and play suspension module that restores the magneride system to factory specs. No splicing needed just plug and play. It took a long time to find the correct parts and build the...

It's most likely not causing a draw. With the bypass installed you will be removing the suspension module.

Any non-magnetic-ride shocks for a C6 corvette 2005-2013. I recommend the bilstiens but there are cheaper ones available. Check rockauto.com for a good selection and price.

yes call me at 843-543-5253 or strandcaster@currently.com

Contact me at Strandcaster@currently.com. I'll give you info to fix this problem. You can get your money back on those casper simulators. My fix cost $425. I had to raise my price by $50 due to increase cost for parts. 100% money back guarantee. I've never had an unsatisfied customer.