Latest activity
-
Mad_Trbo replied to the thread Help! Need a top module.Did we ever find a source for new or refurbished Folding Top Controllers? -
Hello All. I've been on quite the odyssey, swapping the tired LC3 drivetrain out for an LT-4 drivetrain. I ended up using the LT-4...
-
thebluemax replied to the thread Max Din Display for the XLR.I understand. Mine is a 2004 with 13k on it. I bought it in 2018 with less than 5K. So I am in the same boat as you about 1k a year... -
CY1957-XLR replied to the thread Max Din Display for the XLR.@thebluemax I'll keep following this and see where it goes. Maybe once a few of these are out there, installed and working well, then... -
thebluemax replied to the thread Max Din Display for the XLR.CY1957 The silver is close enough for me as it is definitely way better looking than the original black. I could be wrong but I thought...
-
CY1957-XLR replied to the thread Max Din Display for the XLR.Nice video and explanation from Knights on this. Based on it being an "aftermarket part", color match is not bad. The OEM silver...
-
thebluemax replied to the thread Max Din Display for the XLR.We made the goal of 80 units!!!! :) Should be getting them shortly. (y) There was a delay in order to tweak the color of the bezel...
-
-
nvme replied to the thread Thanks to JustDennis.Thanks Mickeytee thats good advice and I will try RubyRed sytem of taking the top clip off and unscewing and put the new one on when it... -
Mmickeytee replied to the thread Thanks to JustDennis.If one failed you really need to replace both. It may hold the trunk open but its not assisting the pump to lift the trunk. Extra effort...
-
nvme replied to the thread Thanks to JustDennis.Just a little info in case that someone out there don't know here is what I did. My trunk wouldn't stay up so I needed to replace the...
-
So I had to finally replace the gas struts for my Trunk. The Passenger Side is easy but the Driver's Side is a mother. However, there... -
Mmickeytee replied to the thread Thanks to JustDennis.Yes . a little micro torch. Cheap at harbor freight. Without some heat you are correct they will snap right off
-
RRubyRod replied to the thread Thanks to JustDennis.Before starting this project I shopped far and wide looking for just such a tool. No joy. I was tempted to grind down a longer...
-
Mmickeytee replied to the thread Thanks to JustDennis.
-
-
Mmickeytee replied to the thread Thanks to JustDennis.All i use is a thin long screwdriver you just slip it behind the bottom clip and twist and the ball end pops right off. I do so many i...
