Hello,
I am having trouble programming my year appropriate key fobs into my 2006 XLR with my Tech II. I have a 2004 XLR, that is now for parts,, and when it was drivable, I reprogrammed RCDLR to 4 replacement fobs in series with no issues using the rear key slot. I have been through the process...
Confirmed solution.
The factory amp does communicate with the ACC and the ACC will not work without it.
As mentioned in my last post, I hooked up the factory amp from my 2004 into my 2006 through the C3 connector, ran power and a ground to the amp pins in the C1 connection port, and in the...
Update,
In my 2004 service manual(s) I found the following note related to the amp and the ACC in Volume 2 on page 11-85.
" Radio Amplifier
The amplifier receives audible warning commands via a class 2 message from the BCM. The chime alerts the vehicle driver to certain ACC vehicle conditions...
Hello,
This is an old post and just to clarify the importance of the amp.
For the sake of hanging onto the amp, it sends a signal to the ACC, so when the previous owner tossed it and upgraded the stereo in my 2006, his shortfall disabled the ACC, and also seems to have restricted the key fob...
Hi,
This info is a start and takes me further than I have been in the past few years with this issue.
All of my steering wheel controls work, and we have tested them. With that I don't think that I need anything from the factory radio or head unit. Its the power or communication to the ACC...
Hello,
Trying to keep the ACC and amp connection in the best place for future reference.
I have a 2006 with a Kenwood aftermarket stereo and amp that was installed in the car when I bought it.
The aftermarket installers tossed the factory amp and based on this post, I believe that is why my...
Hello,
I can get that part for you. It will have to be next week in that I am not at home this weekend.
When I have images of the part I will send them to you in a PM.
FTH
Update:
There is a full set of interior and some body parts available in this salvage 2004 as below.
Right now I plan to keep parts of the drive train. The driver side upper A arm is sheared off, not sure of the status of the front mono leaf spring. I would not feel comfortable selling any of...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.