Welcome to the Cadillac XLR Forums!

Recent content by madcurl

  1. madcurl

    HRE 543R: Testing clearances on 2007 XLR

    Nearly 50,000 miles later; its getting time for replacement tires. In the meantime I've enjoyed every mile on them. Sent from my iPhone using Tapatalk
  2. madcurl

    CUSTOM WHEEL GALLERY: XLR/XLRV

    Nice. Thanks for posting [emoji106] Sent from my iPhone using Tapatalk
  3. madcurl

    HRE 543R: Testing clearances on 2007 XLR

    Sent from my iPhone using Tapatalk
  4. madcurl

    HRE 543R: Testing clearances on 2007 XLR

    Sent from my iPhone using Tapatalk
  5. madcurl

    CUSTOM WHEEL GALLERY: XLR/XLRV

    255/35/20. I spoken the dealership that was selling the car, but I forgot. Sent from my iPhone using Tapatalk
  6. madcurl

    HRE 543R: Testing clearances on 2007 XLR

    After several years it's time to buy another set of run flats. These tires I've had since 2015 I think [emoji189] and now I have over 78,000 on the odometer and it's down to the wear bar in the rear. Sent from my iPhone using Tapatalk
  7. madcurl

    Do you see XLRs??

    I was leaving work while out of town when my girlfriend snapped a surprise picture of me (at car level) as I was driving down the street. Yes Graytoad my 2007 XLR has the body panels of the 2009 (front & rear). Sent from my iPhone using Tapatalk
  8. madcurl

    Do you see XLRs??

    Sent from my iPhone using Tapatalk
  9. madcurl

    CUSTOM WHEEL GALLERY: XLR/XLRV

    Sent from my iPhone using Tapatalk
  10. madcurl

    CUSTOM WHEEL GALLERY: XLR/XLRV

    Sent from my iPhone using Tapatalk
  11. madcurl

    HRE 543R: Testing clearances on 2007 XLR

    Picked up the parts for the rear sway bar from the XLRV. I hope to have the bar installed next week. The bucket list: 1. Purchase 2009 body panels. Check 2. Install 2009 exhaust tip bezel. Check 3. Install XLRV rear sway bar. 4. Instal Borla exhaust system. 5. Install iPhone adapter kit...
  12. madcurl

    CUSTOM WHEEL GALLERY: XLR/XLRV

    Sent from my iPhone using Tapatalk
  13. madcurl

    HRE 543R: Testing clearances on 2007 XLR

    Close enough[emoji3] Sent from my iPhone using Tapatalk
  14. madcurl

    HRE 543R: Testing clearances on 2007 XLR

    Sent from my iPhone using Tapatalk Removal of the protective film. I now need to find a single exhaust pipe (for a better sound and weld one end to the cut pipe and allow the distal end fit inside the exhaust bezel.
  15. madcurl

    HRE 543R: Testing clearances on 2007 XLR

    So, the inside of the two tail pipes were cut in a pie like section. This allowed for bending the pipes 1/2" per side inward. I'll need to now have the small area welded (not at this shop but later). Sent from my iPhone using Tapatalk
Back
Top Bottom