Search results

Blower Motor Replacement Procedure? Does anyone have the procedure for replacing the blower motor? Thank you in advance!

Thanks for the info! Sounds like it's not going to be an easy diagnosis. The controller powers up fine and I can hear the a/c compressor kick on, but no air blows. Hoping for the best!

I don't know which resistor. I came to that conclusion through a google search, but GM Parts Direct says there isn't a resistor in the XLR blower.

HELP! I ran my car through a car wash today and immediately smelled an electrical burning smell and the HVAC blower stopped working. Fuses look ok and the compressor still kicks on but no air blows. Where do I begin? I'm assuming water somehow got to the resistor and knocked it out. I don't know...

HELP! I ran my car through a car wash today and immediately smelled an electrical burning smell and the HVAC blower stopped working. Fuses look ok and the compressor still kicks on but no air blows. Where do I begin? I'm assuming water somehow got to the resistor and knocked it out. I don't know...

I'll give it a try tonight, but I'm thinking it's a bad part. After a second drive, I can tell the ride control has defaulted to soft mode. Man, these cars can be a pain! lol Thanks for your suggestions, Coop

I disconnected the battery during the install and then reconnected it. Took maybe five minutes. Does it need to be disconnected longer?

Hi everyone. My ride control module got wet and I ordered a used replacement part on eBay. Upon installation, I still get the service ride control light. Does anyone know if this requires some kind of reprogram to turn it off? It was driving fine with the previous module.. And it appears to...

Thanks! CC! I will try to find some additional info on replacing the ballast! That would probably be the next cheapest thing to try.

Thx, CCClarke, I attempted to replace the entire headlight assembly (assuming the ballast is part of that?)

Hey gang, looking for some insight on my passenger side headlight. It flickers but won't stay lit. The drivers side works fine. When I turn on the high beam, the passenger side beam shuts off completely but the drivers side works fine. However, when I try to switch back to low beam, it stays...

Mine does this anytime water gets in the trunk near the pump. Check to make sure it's dry. Trust me, I'm spending a fortune replacing the trunk top module and ride control module after a flood in the rear compartment due to rain. Not fun... Coop

Hey everyone, quick update... I installed the Top Control Module on Saturday. It took about a hour and 20 minutes, but much of that time was spent trying to figure out how to unattach the wiring. Some of the connectors were a little tricky. Once that was done, everything was smooth sailing...

Thanks everyone. Not trying to get the website in trouble... just looking for some answers! Sorry for the delayed response. My part just arrived in the mail and i'm hoping to do the swap out this weekend. Wish me luck!

Thanks, XFireXLR. I appreciate any help I can get. I will also be replacing the suspension control module at some point, but that appears to be a quick exchange and plug in. Best, Coop

All, my FTC module shorted as a result of the trunk filling with water. Anyone know the steps involved in replacing the FTC module? I know it will need to be reprogrammed, but I would like to save some money and replace the module myself if it's not too involved. Thanks in advance! Coop