Recent content by Pbsilberman

As he said. I had to do this several times to open the door (then hood) after the battery was drained flat. Use two hands and lift evenly to avoid twisting the trunk lid.

I had the same doubt when another thread said to add fluid even if not at low line but with the low cost of the DOT3, I went ahead. BTW, I used a name brand DOT3 from the auto parts store rather than a dealer trip.

I have a 2006 XLRV so YMMV. My reservoir is marked with raised letters and a line in the same plastic as the reservior. It is located towards the back of the reservoir of the fender side. If your reservoir is at all dirty, give it a good wipe first. My line is a touch below where the flat side...

Adding brake fluid to the max line fixed mine. Sent from my iPad using Tapatalk

Like others say,it will turn off.For your own peace of mind, check back at the car a half hour later to see if the blue light of the bluetooth adatpter goes out.,

The XM connector is behind the rear compartment between the seats, in interior compartment. Just four screws to remove.The cable runs free in the small gap to the center console. No drilling needed. PM an email if you would like pics to better explain.

+1 on Stabilus. Excellent price/quality/delivery.

That what I thought when I bought the AUX2. However, after my harness install, the XM volume is lower when nothing is plugged in than it was before. I don't know if I have a bad connection in the harness or if the receptacle that does the XM/BT switching add resistance to the circuit lowering...

The parts I used in addition to the AUX2 and BTC455 are: LGB-1 from HTD.com Line Level Gain Boost 8" 3.5mm patch cable 3.5mm Patch Cable a 12v power supply for the amp Amazon.com: HitCar 12V 12-Volt 24V DC 2.1mm Car Truck Bus Van Boat Cigarette Lighter Power Supply Adapter Charger Cable: Cell...

Another possibility is that your instructions and other people's no volume loss reports were written for the AUX1 harness and my install was the AUX2. The difference in the harness may affect the volume. Considering my experience and yours, I'd suggest using the AUX-1F VRT unless the owner...

I got all installed and am pretty happy with the result. On the amp, I think I followed the CC instructions and the volume was lower. Possibly the reason was I wanted to leave the phone at the volume I use for headphones rather than crank it to full. The amp fixed the issue though. I can switch...

My Kinivo is coming in today so I'll get to that part tonight. If you haven't worked with the type of connectors that the harness uses before, getting the connector off the XM box can be a challenge. I'd suggest plugging and unplugging the harness connectors from itself a few times to get...

Thanks. Needless to say, I din't wait long enough to time out. BTW, also thanks for sending the XLR instructions to Ray who forward them on to me after the order. They really helped a novice with the install

I just did the install using the Kawal AUX2-VRT harness. He also sells a fuse jumper that lets you change the 12v outlet for bluetooth to only be hot in the acc/run mode so the bluetooth isn't always on and run down the battery. It replaces fuse #35 in my 2006 xlr. the extra $10 for the jumper...

Yep. My friends and I would go an hour before the pumps turned on, park by a pump and go next door to the Burger King to wait. Gas at $1 per gallon? Outrageous.