VLEDS DRL/Turn Signal

[KOSletten]

One of the first things I did with my recently acquired 2008 XLR was swapping out the DRL/Turn signal 3757A bulbs with VLEDS V6 Extreme White Amber Switchback 3157-Resistor Free kit. The kit is a bit on the expensive side but is of high quality and there was no cutting or splicing of the factory wiring required. Video of the VLEDS in my XLR.

KO

 

[lextoy]

Nice setup. Where did you stick on the resistors, do they get hot enough that it's a worry? Everything around the fenders/engine compartment is plastic , SMC.
The new LED bulbs I have ended up not doing switchback, and they hyper flash, which I don't mind. No dash warnings, so that's great. Will see if it's a problem at inspection time. Have to do annual inspections in PA. LOL

 

[KOSletten]

Nice setup. Where did you stick on the resistors, do they get hot enough that it's a worry? Everything around the fenders/engine compartment is plastic , SMC.
The new LED bulbs I have ended up not doing switchback, and they hyper flash, which I don't mind. No dash warnings, so that's great. Will see if it's a problem at inspection time. Have to do annual inspections in PA. LOL

There is not a separate resistor, just a small controller module that I zip tied to some of the wires behind the headlight assembly.
V6 EXTREME WHITE AMBER SWITCHBACK 3157 - RESISTOR FREE

KO