Victor's top goes through all the steps fine going up & down, but the trunk stops when it is suppose to close, the final step. It will rock down slightly for an instant and the motor is running, but it won't close. This happens whether the top is being put up or down. If you release the top switch then press it again, the trunk will close but no chime. This has probably started happening the last half dozen full up/down cycles.
Today after putting the top up & doing the pause then push the top switch trick to close the trunk, I tried opening the trunk by itself - no go using the cabin button, fob, or touch pad. You could hear the latch release, but the trunk didn't move at all. I then pushed the top switch to put the top down, the trunk then raised & I cycled through top up & down fine, less the usual trunk not closing issue. I thought it was a tonneau sensor issue until this happened.
I replaced the trunk rubber bumpers before this problem started but I wouldn't think that would have caused the issue.
I own a Tech II so if there is a way to diagnose the issue let me know (CC Clarke).
Mike
Today after putting the top up & doing the pause then push the top switch trick to close the trunk, I tried opening the trunk by itself - no go using the cabin button, fob, or touch pad. You could hear the latch release, but the trunk didn't move at all. I then pushed the top switch to put the top down, the trunk then raised & I cycled through top up & down fine, less the usual trunk not closing issue. I thought it was a tonneau sensor issue until this happened.
I replaced the trunk rubber bumpers before this problem started but I wouldn't think that would have caused the issue.
I own a Tech II so if there is a way to diagnose the issue let me know (CC Clarke).
Mike