Hi all
I have been asked to help with setting up the distributor angle on a 1995 GMC (might be Chevy) Day van. It is the design where there is a big disk being used to measure crank (or cam) angle as part of the distributor. I don't know much about it but as I have a Tech-2 I have been asked to help set the thing up.
So, by any chance, can anyone send me the w/s pages on setting the distributor for a 1995 Vortec. It is the small block as fitted to the Astro, Suburban, Tahoe etc. At the moment it more or less runs OK, but keeps setting a code. Basically the problem is that it isn't at the correct base angle. I assume there is some kind of TDC setting required too.
TIA
I have been asked to help with setting up the distributor angle on a 1995 GMC (might be Chevy) Day van. It is the design where there is a big disk being used to measure crank (or cam) angle as part of the distributor. I don't know much about it but as I have a Tech-2 I have been asked to help set the thing up.
So, by any chance, can anyone send me the w/s pages on setting the distributor for a 1995 Vortec. It is the small block as fitted to the Astro, Suburban, Tahoe etc. At the moment it more or less runs OK, but keeps setting a code. Basically the problem is that it isn't at the correct base angle. I assume there is some kind of TDC setting required too.
TIA
